Direction to replace a Wireless Phone

First turn off the old wireless phone…..

From your desk phone do the following

Enter 2286633#

Press Hold

+++ this will put you in CAT mode +++

Press ST

+++ Display will show Command= +++++

Dial 1 on the keypad

Press D   +++See note below++++

Dial 21 on keypad

Press DE

Enter extension you would like to replace on the keypad

Press DE

Using the keypad enter your new serial number (should be in the form of 0003xxxxx) The old should have showed on the screen before you begin entering the new serial number if you have the old phone verify the old serial number matches. (The Serial number is located under the batter in the telephone).

Press EXE

Press ST

Dial 1 on the keypad

Press D  

Dial 20 on keypad

Press DE

Dial * and the extension you will be replacing on keypad

Press DE

Dial 1 on the keypad

At this point take the new phone and turn it on by pressing the power button and the transfer button at the same time. Awaiting download should come up on the screen. When the phone begins to beep Press EXE on your desk phone.

At this point the wireless phone display should show Now Downloading, then show complete and the phone will reset and you are done.

Lift the handset on your desk phone and replace it to the cradle to exit programming mode.

*****Guide to finding the Special Characters needed to program a telephone