Direction to replace a Wireless Phone
First turn off the old wireless phone…..
From your desk phone do the following
Press TRANSFER
Press CONFERENCE
Dial *
Press TRANSFER
Press CONFERENCE
Dial #
+++ this will put you in CAT mode +++
Press REDIAL
+++ Display will show Command= +++++
Dial 1 on the keypad
Press Line Key 4 +++See note below++++
Dial 21 on keypad
Press RECALL
Enter * and the extension you would like to replace on the keypad
i.e. extension 400 is entered as *400 THIS MAY NOT BE THE EXTENSION NUMBER METHOD DEPENDING WHO INSTALLED YOUR SYSTEM, IF YOU ARE UNSURE CONTACT TECHNICAL SUPPORT 540-432-1385
Press RECALL
Using the keypad enter your new serial number (should be in the form of 0003xxxxx) The old
should have showed on the screen before you begin entering the new serial number if you
have the old phone verify the old serial number matches. (The Serial number is located
under the batter in the telephone).
Press CONFERENCE
Press REDIAL
Dial 1 on the keypad
Press Line Key 4 +++See note below++++
Dial 20 on keypad
Press RECALL
Dial * and the extension you will be replacing on keypad
Press RECALL
Dial 1 on the keypad
At this point take the new phone and turn it on by pressing the power button and the transfer
button at the same time. Awaiting download should come up on the screen. When the phone
begins to beep Press CONFERENCE on your desk phone.
At this point the wireless phone display should show Now Downloading, then show complete
and the phone will reset and you are done.
Lift the handset on your desk phone and replace it to the cradle to exit programming mode.
